Operation Manual

SWINGARM
4-99
EAS23340
REMOVING THE SWINGARM
1. Stand the vehicle on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there
is no danger of it falling over.
TIP
Place the vehicle on a suitable stand so that
the rear wheel is elevated.
2. Measure:
• Swingarm side play
• Swingarm vertical movement
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Measure the tightening torque of the drive
pulley assembly bolts, swingarm bolts and
pivot shaft nut.
b. Measure the swingarm side play “A” by
moving the swingarm from side to side.
c. If the swingarm side play is out of specifica-
tion, check the bearings.
d. Check the swingarm vertical movement “B”
by moving the swingarm up and down.
If swingarm vertical movement is not
smooth or if there is binding, check the
bearings.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Remove:
•Drive belt
Refer to “BELT DRIVE” on page 4-92.
4. Remove:
• Drive pulley assembly bolt
• Swingarm bolt
• Pivot shaft nut
EAS23371
CHECKING THE SWINGARM
1. Check:
• Left swingarm “1”
• Right swingarm “2”
Bends/cracks/damage → Replace.
2. Check:
• Drive pulley assembly bolts
• Swingarm bolts
Damage/wear → Replace.
EAS28780
INSTALLING THE SWINGARM
1. Lubricate:
• Taper roller bearing
TIP
Lubricate the space in the swingarm with lith-
ium-soap-based grease before installing the
taper roller bearing.
2. Install:
• Pivot shaft “1”
• Washer “2”
• Pivot shaft nut “3”
Drive pulley assembly bolt
48 Nm (4.8 m·kgf, 35 ft·lbf)
Swingarm bolt
40 Nm (4.0 m·kgf, 29 ft·lbf)
Pivot shaft
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Pivot shaft nut
100 Nm (10 m·kgf, 72 ft·lbf)
Swingarm side play (at the end
of the swingarm)
1.0 mm (0.04 in)