Operation Manual

CYLINDER HEAD
5-19
EAS24120
REMOVING THE CYLINDER HEAD
1. Remove:
• Cylinder head bolts
• Cylinder head nuts
TIP
• Loosen the bolts and nuts in the proper
sequence as shown.
• Loosen each nut 1/2 of a turn at a time. After
all of the nuts are fully loosened, remove
them.
EAS24160
CHECKING THE CYLINDER HEAD
1. Eliminate:
• Combustion chamber carbon deposits
(with a rounded scraper)
TIP
Do not use a sharp instrument to avoid damag-
ing or scratching:
• Spark plug bore threads
•Valve seats
2. Check:
• Cylinder head
Damage/scratches → Replace.
• Cylinder head water jacket
Mineral deposits/rust → Eliminate.
3. Measure:
• Cylinder head warpage
Out of specification → Resurface the cyl-
inder head.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Place a straightedge “1” and a thickness
gauge “2” across the cylinder head.
b. Measure the warpage.
c. If the limit is exceeded, resurface the cylin-
der head as follows.
d. Place a 400–600 grit wet sandpaper on the
surface plate and resurface the cylinder
head using a figure-eight sanding pattern.
TIP
To ensure an even surface, rotate the cylinder
head several times.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS24240
INSTALLING THE CYLINDER HEAD
1. Install:
• Dowel pins
• Cylinder head gasket
Warpage limit
0.03 mm (0.0012 in)
Thickness gauge
90890-03180
Feeler gauge set
YU-26900-9
New