Operation Manual

FUEL INJECTION SYSTEM
8-38
5 Crankshaft position sensor
malfunction
Sensor inspection procedure
Refer to “CHECKING THE
CRANKSHAFT POSITION
SENSOR” on page 8-135.
Replace if defective.
Crank the engine, and check
the fault code indication.
No fault code indicated.
Recovered.
Fault code indicated.
Check the next step.
6 ECU malfunction Replace the ECU.
Fault code No. 13
Item
Intake air pressure sensor: open or short circuit detected. (no nor-
mal signals are received from the intake air pressure sensor.)
Fail-safe system
Able to start engine
Able to drive vehicle
Diagnostic code No. d:03
Meter display Displays the intake air pressure.
Procedure
Set the engine stop switch to “ ”, and then operate the throttle
while pushing the start switch “ ”. (If the display value changes,
the performance is OK.)
Item/components and
probable cause
Check or maintenance job
Sensor inspection proce-
dure
1 Connection of intake air pres-
sure sensor coupler
Check the connection of the
coupler is secure.
Disconnect the coupler, and
check each pin (for bending,
wear, or locking).
Poor connection Connect it
securely, or repair/replace the
wire harness.
Place the main switch to the
ON position, and check the
fault code indication.
No fault code indicated.
Recovered.
Fault code indicated.
Check the next step.
2 Connection of wire harness
ECU coupler
Check the connection of the
coupler is secure.
Disconnect the coupler and
check each pin (for bending,
wear, or locking).
Poor connection Connect it
securely, or repair/replace the
wire harness.
Place the main switch to the
ON position, and check the
fault code indication.
No fault code indicated.
Recovered.
Fault code indicated.
Check the next step.
Fault code No. 12
Item
Crankshaft position sensor: no normal signals are received from the
crankshaft position sensor.
Fail-safe system
Unable to start engine
Unable to drive vehicle
Diagnostic code No.
Meter display
Procedure
Item/components and
probable cause
Check or maintenance job
Sensor inspection proce-
dure