Operation Manual
FUEL INJECTION SYSTEM
8-65
Fault code No. Er-2
Item
ECU internal malfunction (output signal error): no signals are
received from the ECU within the specified duration.
Fail-safe system
Able to start engine
Able to drive vehicle
Diagnostic code No. —
Meter display —
Procedure —
Item/components and
probable cause
Check or maintenance job
Sensor inspection proce-
dure
1 Connection of meter coupler
Check the connection of the
coupler is secure.
Disconnect the coupler, and
check each pin (for bending,
wear, or locking).
Poor connection → Connect it
securely, or repair/replace the
wire harness.
Place the main switch to the
ON position, and check the
fault code indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
2 Connection of wire harness
ECU coupler
Check the connection of the
coupler is secure.
Disconnect the coupler, and
check each pin (for bending,
wear, or locking).
Poor connection → Connect it
securely, or repair/replace the
wire harness.
Place the main switch to the
ON position, and check the
fault code indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
3 Connection of diagnostic tool
coupler
Check the connection of the
coupler is secure.
Disconnect the coupler, and
check each pin (for bending,
wear, or locking).
Poor connection → Connect it
securely, or repair/replace the
wire harness.
Place the main switch to the
ON position, and check the
fault code indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
4 Continuity of wire harness Open or short circuit → Con-
nect it securely, or repair/
replace the wire harness.
Yellow/blue–Yellow/blue
Place the main switch to the
ON position, and check the
fault code indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
5 Abnormal meter unit opera-
tion
Replace the meter assembly. Place the main switch to the
ON position, and check the
fault code indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
6 ECU malfunction Replace the ECU.