Operation Manual

CABLE ROUTING
2-44
1. Holder
2. Brake hose
3. Lower bracket cover
4. Horn
5. Horn lead
6. Grommet
7. Front fork
8. Front wheel sensor lead
9. Front brake hose holder
10.Cable guide
11.Front brake caliper
12.Front wheel sensor
A. Fasten at a position 0 to 5 mm (0 to 0.20 in)
from the protector end of the brake hose.
B. Route the horn lead along the brake hose.
Make sure that there is no slack in the
lead.
C. Fasten at a position 0 to 5 mm (0 to 0.20 in)
from the bending part of the brake hose.
D. Route the front wheel sensor lead in front
of the brake hose and horn lead.
E. Pass the front wheel sensor lead through
the hole in the lower bracket cover.
F. 10–20 mm (0.39–0.79 in)
G. Fasten the front wheel sensor lead at the
end of the plastic tape.
H. Insert the brake hose joint into the stopper
claw of the horn bracket.
I. Insert the horn lead coupler. Install the
black lead to the bracket side (bottom).
J. Install the horn bracket, aligning the projec-
tion of the horn bracket with the groove of
the horn.
K. 0–5 mm (0–0.20 in)
L. Face the holder opening to the rear of the
vehicle.
M. Bring the both ends of the white tape on
the horn lead into position between brake
hose grommet flanges.
N. White tape
O. Between brake hose grommet flanges
P. Face the holder opening to the front of the
vehicle.
Q. Front of the vehicle
R. Route the horn lead between the holders
under the brake hose. Both routes shown
in the illustration are acceptable.
S. 70–80 mm (2.76–3.15 in)
T. Only the left side, fasten the grommet part
of the front wheel sensor.
U. Route the front wheel sensor lead inside of
the brake hose.
V. Tighten the union bolts, pushing the brake
pipe against the projection of the brake cal-
iper.
W. Pass the front wheel sensor lead through
the cable guide.
X. Route the front wheel sensor lead between
the front brake caliper and the outer tube.