Specifications

35, work nicely).

Loop the hose around the bottom of the yardstick and secure it with wire or twist ties so

that it runs straight up both sides; avoid pinching. Trim the ends to the same length, and

cut an 8" piece from each end. Suck ATF into the line so that it fills the tubing about 8"

high on each side. Splice the end pieces back on with the pilot jets.

Remote Fuel Bottle.

On OEM carbs with a central synchronizing screw,adjustment (see Section II.) is easiest

with the tank removed. Make a remote tank from a 1 qt. plastic bottle. Install a 1/4" hose

barb in the bottom of the bottle and a lawn mower fuel valve in the line (an in-line filter is

also a good idea). Attach a wire to the top of the bottle and hang it where you need it.

Safety note: many plastics will break down with exposure to fuel. Be sure your material

is fuel resistant, and empty the container immediately after use.

This item is not strictly necessary. 5twins recommends rough adjustment with the tank

removed, using fuel remaining in the float bowls, followed by fine adjustment with the

tank in place, reaching in with a long screwdriver. You can also set the tank on a work

bench or other elevated surface and run extensions to the carburetor lines.

Compressor

If you intend to do much mechanical work at all, an air compressor with sufficient

capacity to power an impact wrench will pay for itself quickly. For carb cleaning, attach

an air gun with a rubber tip.

To the best of our knowledge, the text on this page may be freely reproduced and

distributed.

Sale of this information is prohibited.