Specifications

D. ReplacingWheelBearings
Ifthebearingsallowplayinthewheelhuborifwheel
doesnotturnsmoothly,replacethebearings as
follows:
1.Cleantheoutsideofthe - wheel hub.
2. Drivethebearing out bypushingthespacer
asideandtapping around theperimeterofthe
bearing inner racewith a softmetaldriftpin
andhammer.Thespacer " floats " betweenthe
bearings.Bothbearingscanberemovedinthis
manner.
3. To installthewheelbearing,reversetheabove
sequence. Be sure to greasethebearingbefore
installation.Use a socketthatmatchesthe
outsideraceofthebearing as a tool to drive
inthebearing.
5-2REARWHEEL
A.Removal
1.Placemachineoncenter stand.
2. Raise the seat. Unscrewrearfenderinstallation
boltsuntiltheirthreadedportion
iscompletely
out.Raisefender.Reinsertboltsas stoppers
to
supportraised fender.
thecenterraceor
ballsof thebearing.Contactshouldbemade
onlywiththeouterrace.
E.InstallingFrontWheel
Wheninstallingfrontwheel,reversetheremovalpro -
cedure. Note the following points:
1. Lightlygreaselipsoffrontwheeloil seals and
gear teethofspeedometerdriveanddriven
gears. Use lightweightlithiumsoapbasegrease.
2. Makesurethere is enoughgapbetweendisc
pads.
3. Checkforproperengagementofthebosson
theouterforktubewiththelocating slot on
speedometergearunithousing.
4. Alwayssecurethefrontwheelaxle as follows:
a. Tightenthefrontaxlenut.
Axle nut torque:
I 8.3~13m - kg (60~94 ft-lb)
b.Tightenaxleholdernuts.Firsttightennuton
frontendofaxleholder,then tighten nuton
rear end.
I
Holdernuttorque:
I 1.1~1.8m - kg(8.0~13.0ft-lb)
c.Install a newcotterpin.
3. Removethemufflerprotector.
4. Removetheaxlenutcotterpinandtheaxle
nut.
5. Loosen the rearaxlepinchbolt.
6. Whilesupportingthebrake caliper, pull
out
therearaxle.
7. Holdupthebrake caliper assembly and place
it onthehookoftherear arm.
8. Movethewheel to therightside to separate
it
fromthefinalgear case andremovethe
rear
wheel.