User Manual
Table Of Contents
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Starting Dante Controller
- Using Dante Controller
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2014 Audinate Pty Ltd. All rights reserved.
-61-
Configurable Parameters
Rename Device
Allows you to enter a new Dante 'friendly name' for the device. The text field displays the current name.
To change the device name, enter a new name in the text field and press Enter.
See Device Names and Channel Labels for information about name conflicts and device name rules.
Sample Rate
n Shows the current sample rate of the device, and allows you to change the operating sample rate of
the Dante device. This may require the device to be rebooted to take effect. All sample rates sup-
ported by the device are shown in the drop down menu.
n Shows the current pull-up/down setting for the device, and allows you to change the pull-up/down set-
ting. The pull-up/down setting can be used to adjust the sample rate of the device to synchronise
audio with video that has undergone frame rate conversion. For example, to synchronise Dante audio
with video that has been converted from 24 fps to 25 fps, set the sample rate pull-up/down for any rel-
evant Dante audio devices to +4.1667%.
Note: Changing the sample rate pull-up/down for a device places that device in a dedicated clock
domain. Dante devices can only transmit audio to, or receive audio from other devices on the same
clock domain. See Clock Status View for more information.