User Manual

Controls and Functions
XMV8280/XMV8140/XMV8280-D/XMV8140-D Owner’s Manual
11
!4 [PRIMARY]/[SECONDARY] indicators
(XMV8280-D/XMV8140-D only)
These show the communication status of the Dante [PRI-
MARY]/[SECONDARY] connectors @1. They flash rapidly
in green if the Ethernet cables are connected properly.
!5 [SYNC] Indicators
(XMV8280-D/XMV8140-D only)
These show the operating status of the Dante network. If the
green (upper) indicator lights, the unit is operating as a word
clock slave and synchronizing to the word clock. If the green
indicator flashes, the unit is operating as the word clock mas-
ter. If the power to the unit is turned on but the green indica-
tor is turned off, the unit is not functioning properly. In this
case, refer to the “Warning Messages” section (see page 29).
If the orange indicator lights or flashes, refer to the “Warning
Messages” section.
!6 [PANEL LOCK] indicator
This lights or flashes according to the state of the front panel
lock. To specify the front panel lock setting, use the Device
setup DIP switch @3.
!7 [FUNCTION] button
Use this to check or change the operating mode of the
XMV’s front panel. For details on how to perform front
panel operations, refer to “Front Panel Operations” (page
23).
!8 Cooling vent
Located behind the vent is a variable speed cooling fan that
draws air in from the front and exhausts it through the rear.
The fan speed will automatically vary according to the tem-
perature.
Please be sure that you do not block the air intakes or
exhaust vents. You should also clean the air intakes and
exhaust vents regularly. If the air intakes are clogged with
dust or debris, the unit will overheat, which may result in the
unit shutting down.
Indicator Status
Lit
Front panel operations are locked. Lock
will be temporarily defeated if you press
the [FUNCTION] button !7 and the
[SELECT] A button t.
Unlit Front panel operations are not locked.
Flashing
Lock is temporarily defeated. When the
XMV is restarted, it will be in a locked
state.