User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 10 Component editor (TXn only)
Amp Editor Owner’s Manual
177
Single
Use this setting if a device operating at the conventional 44.1/48 kHz is connected, and the conventional
number of channels is being transmitted and received without change. The sampling rate is converted for
each channel of the digital I/O card, and transmitted or received at half the sampling rate of the operating
frequency (i.e., at 44.1/48 kHz). (This setting can be selected only for a digital I/O card that does not sup-
port 96 kHz.)
MY16-CII
Here you can specify the input/output mode and CobraNet bundles for an MY16-CII card inserted in the slot.
q
w
e
r
t
y
u
i
o