User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 5 Main panel window
Amp Editor Owner’s Manual
66
Clock
Click the [Device] menu command [Clock...] to access the “Clock Setup” dialog box.
Here you can set the internal clock of the connected device. You can also enable daylight saving time. Click the
[OK] button to apply the modified settings and close the dialog box. Clicking the [OK] button will send the com-
puter’s date and time to the devices to set them, regardless of the Automatically Adjust Device Clocks setting.
Automatically Adjust Device Clocks
Here you can synchronize the device’s internal clock to the computer’s clock time. There are two ways to set
this.
[When Synchronized] check box
The time will be set when synchronizing with the device.
[Daily (works only while online) at :]
If Amp Editor is always running, the clock will be set each day at the specified time. Use the box at right
to specify the time at which the clock will be set. To change the value, use the upward [s] button and
downward [t] button located at the right side of the box.