User Manual

3. Add a check mark to the check box for a desired Snapshot number in the Control PINs column.
Input/output ports are added to the components on the sheet. The recall method is the same as the "■
An example of control using the Snapshot component".
[2] An example of control using a Sel pin
1. Select Parameter.Set in the “Parameters” area, and then add a check mark to the "Sel" in the Control
PINs check box, it will be added to the input port of the component on the sheet.
2.
Enter a desired number（1 to 100) into the Sel input pin. The Snapshot component corresponding to
that number is recalled. (At this time, the output pin for this component outputs “1.”)
13. Audio Processors : DME7
130 | ProVisionaire Design User Guide