User Manual

13.11. “Parameter Sets” area
A set of parameters stored or recalled as a snapshot is called a “parameter set.” Storing a snapshot saves the
current values of the parameter set members. One parameter set can store up to 100 different snapshots. A
parameter can be registered in more than one parameter set.
Parameters can be registered in a parameter set in the following ways.
Registration source Registration method
Design sheet While holding down <Ctrl>, drag and drop a component onto a parameter
set name.
Right-click a component, and use [Add to Parameter Set] to select the
parameter set to which it will be registered.
Component editor While holding down <Ctrl>, drag and drop a parameter onto a parameter
set name.
“Parameters” area*1 Drag and drop the component or parameter onto a parameter set name.
Right-click the component or parameter, and use [Add to Parameter Set]
to select the parameter set to which it will be registered.
“Parameter Sets” area After selecting the parameter set to register, click the [Add Device] button
to register all components placed at that point.
*1. You can also use <Shift> or <Ctrl> to simultaneously register multiple components or parameters in a
parameter set.
13. Audio Processors : DME7
ProVisionaire Design User Guide | 137