Operation Manual

PRE-OPERATION CHECKS
4-2
4
NOTE:
@
Pre-operation checks should be made each time the motorcycle is used. Such an inspection can be accomplished in a very
short time; and the added safety it assures is more than worth the time involved.
@
EWA00033
WARNING
@
If any item in the Pre-operation check list is not working properly, have it inspected and repaired before operating
the motorcycle.
@
Control cables
• Make sure that operation is smooth.
• Lubricate if necessary.
6-25
Wheels and tires
• Check for damage.
• Check tire condition and tread depth.
• Check air pressure.
• Correct if necessary.
6-16–6-19
Brake and shift pedals
• Make sure that operation is smooth.
• Lubricate pedal pivoting points if necessary.
6-26
Brake and clutch levers
• Make sure that operation is smooth.
• Lubricate lever pivoting points if necessary.
6-26
Sidestand
• Make sure that operation is smooth.
• Lubricate pivot if necessary.
6-27
Chassis fasteners
• Make sure that all nuts, bolts and screws are properly tightened.
• Tighten if necessary.
—
Instruments, lights, signals
and switches
• Check operation.
• Correct if necessary.
—
Sidestand switch
• Check operation of ignition circuit cut-off system.
• If system is defective, have Yamaha dealer check vehicle.
3-17
ITEM CHECKS PAGE
U5SCE0.book Page 2 Thursday, June 7, 2001 11:24 AM