manual

12
En
Settings
Once you program the sound bar, you can control it with your TV’s remote control for
functions such as turning on/off the TV and sound bar simultaneously, or volume up/
down and muting/unmuting of the sound bar.
1 Turn off the TV.
2 Turn off the sound bar.
3 Hold down the LEARN key on the sound bar’s remote control for
more than 3 seconds while pointing at the appropriate remote
control sensor (p.5).
The sound bar enters the learning mode, and the indicators on the top panel flash
as shown below.
4 Check if the appropriate remote control sensor has been activated.
You can check which remote control sensor has been activated with the CLEAR
VOICE indicator.
If the appropriate remote control sensor has not been activated, press the LEARN
key to exit from the learning mode, and repeat from Step 3.
NOTE
• Steps 5 to 8 require only the TV’s remote control and the keys on the rear panel of the sound bar.
The remote control of the sound bar is not necessary.
• If the sound bar has already learned functions, the following indicators light up.
Mute: TV
Volume (-): BD/DVD
Volume (+): ANALOG
Power: BLUETOOTH
5 Teach the sound bar the “Mute” code of the TV’s remote control.
5-1 Press (mute) on the rear panel of the sound bar.
5-2 While pointing your TV’s remote control at the remote control sensor, hold
down the mute key for more than 1 second twice or three times.
The appropriate remote control sensor depends on the installation position (p.5).
Programming the sound bar with the TV’s remote
control (TV’s remote control learning function)
• This function is available only when your TV’s remote control uses IR (infrared) signal.
• A radio wave remote control will not work.
• If you want to use a cable or satellite set top box’s remote control to operate the sound bar, use your
original TV’s IR (infrared) remote control to program the sound bar, then use the set top box’s remote
control to operate.
• If by changing the volume of the sound bar the TV’s volume also changes, set the TV’s volume to
minimum, or disable speaker output.
CLEAR VOICE
indicator
Activated remote control
sensor
Activated remote control
sensor is appropriate when…
Off On the front panel
Installing the sound bar on a TV
cabinet, etc.
Lights up On the top panel
Attaching the sound bar to a
wall
LEARN BLUETOOTH
STANDBY
CLEAR
VOICE
CLEAR
VOICE
Result Bleep/buzzer Indicators
Successfully
learned
Once
Failed to learn
* Repeat from
Step 5-1.
Twice
Approx. 30 cm (1 ft)
TV’s remote control
Hold down
(more than 1 second)
Release
(more than 1 second)
Hold down
(more than 1 second)
Release
(...)
Lights up
Flash