User Manual

ManualsBrandsYamaha ManualsOtherYCH-585

CHIMES

YCH585

Thank you for selecting the YAMAHA chimes.

Please read this owner’s manual carefully, and truly enjoy this instru-

ment for years to come.

OWNER’S MANUAL

Make sure to read the PRECAUTIONS before assembling.

ych585E.pm6 07.1.19, 2:11 PMPage 1 AdobePageMaker6.0J/PPC

Summary of content (4 pages)

PAGE 1
CHIMES YCH585 OWNER’S MANUAL Thank you for selecting the YAMAHA chimes. Please read this owner’s manual carefully, and truly enjoy this instrument for years to come. Make sure to read the PRECAUTIONS before assembling. ych585̲E.pm6 Page 1 07.1.19, 2:11 PM Adobe PageMaker 6.
PAGE 2
PRECAUTIONS Warning Disregard of the warnings with this mark or misuse may result in death or personal injury. Before you use the chime, carefully read the instructions listed below and the owner’s manual. Cautions when setting the instrument. Never place the instrument on an sloping, unstable, etc., platform. The instrument may fall or overturn and result in injury. Cautions for treatment of the instrument. Never lean on or climb onto the instrument. The instrument may fall and result in injury.
PAGE 3
ASSEMBLY PROCEDURE 1 Insert the side columns into the base. At this time, make sure that the damper rest, attached at the center of the column, and the short section of the column is positioned upright. Side Column 3 Remove the damper stay, attached to the bottom of the damper, loosen the wing bolt on the damper stay, and attach the stay to the pedal hook. The pedal’s position can be controlled by adjusting the length of the pedal stay with its two wing bolts.
PAGE 4
ASSEMBLY PROCEDURE 5 To activate the damper stopper, depress the pedal and press the stopper. When the pedal is released, the stopper will hold the damper in place. 6 Before hanging the sound columns on the hanger, activate the damper stopper. Position the sound column with its pitch inscription facing forward, place one side of the wire/strings into the slot of the fixing pin. Next, hook the wire/strings on the hanger pin, finally place the wire/strings into the slot of the remaining fixing pin.