User Manual

22
YDP-103 Owner’s Manual
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct orientation. Please assemble the unit in
accordance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Assemble the unit on a hard and flat floor with ample space.
• Be sure to use the included screws only, and insert screws
of the correct size in the correct hole locations. Use of
incorrect screws can cause damage or malfunction of the
product.
• Be sure to tighten all screws upon completing assembly of
the unit.
• To disassemble, reverse the assembly sequence given
below.
Remove all parts from the package and make sure you
have all of the items.
* The adaptor may not be included, or may look different from the
illustration above, depending on your particular area. Please
check with your Yamaha dealer.
1. After untying the bundled pedal
cord on C, attach C to D and E and
fasten the screws (1-3).
1-1 Untie and straighten out the bundled pedal
cord.
1-2 Align D and E with each end of C.
1-3 Attach D and E to C by finger-tightening
the long screws
1 (6 x 20 mm).
2. Attach B.
Depending on the model of digital piano you
purchased, the surface color of one side of B may
be different from the other side. In this case,
position B so that the side of the surface color
similar to D and E faces the player.
2-1 Place the lower side of B on each foot of D
and E, then attach the upper side to D and E.
2-2 Attach the top of B to D and E by finger-
tightening the thin screws
3 (4 x 12 mm).
2-3 While pressing on the lower part of D and E
from the outside, secure the bottom ends of
B using two tapping screws
4 (4 x 20 mm).
2-4 Insert the other two tapping screws 4 (4 x
20 mm) into the other two screw holes to
secure B.
Have a Phillips-head (+) screwdriver of the appropriate size
ready.
E
A
B
C
D
Bundled pedal cord inside
AC adaptor
Cord holder
Screws set
1 6 x 20 mm
long screws x 4
2 6 x 16 mm
short screws x 4
3 4 x 12 mm
thin screws x 2
4 4 x 20 mm
tapping screws x 4
D
E
C
1
-
3
1
-
2
1
-
1
C
Untie the two vinyl strings.