User Manual
Keyboard Stand Assembly
23
YDP-103 Owner’s Manual
2-5 Securely tighten the screws on the top of B
that were attached in Step 2-2.
3. Secure C.
Securely tighten the screws on C that were
attached in Step 1-3.
4. Mount A.
Be sure to place your hands at least 10 cm from
either end of A when positioning it.
CAUTION
• Fingers can become pinched between the main unit and the
rear or side panels, be extra careful so as not to drop the
main unit.
• Do not hold the keyboard in any position other than the
position shown in the illustration.
5. Secure A.
5-1 Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2 Secure A by tightening the short screws 2
(6 x 16 mm) from the front.
6. Connect the pedal cord and the AC
adaptor.
6-1 Insert the pedal cord plug to the
[TO PEDAL] jack from the rear.
6-2
Securely wind the cord holder around the
pedal cord.
The cord holder is attached to D.
6-3 Insert the AC adaptor plug into the DC IN
jack from the rear.
D
E
B
2
-
3
2
-
3
2
-
4
2
-
2, 2
-
5
2
-
1
Place the
bottom ends
of the rear
panel on
each foot.
3
C
B
D
E
D
E
B
A
At least
10 cm
At least
10 cm
5
-
1
5
-
2
Projection of A