User Manual

Keyboard Stand Assembly
31
YDP-163/YDP-143 Owner’s Manual
2. Attach B.
Depending on the model of digital piano you
purchased, the surface color of one side of B may
be different from the other side. In this case,
position B so that the side of the surface color
similar to D and E faces the player.
2-1 Place the lower side of B on each foot of D
and E, then attach the upper side to D and E.
2-2 Attach the top of B to D and E by finger-
tightening the thin screws
3 (4 x 12 mm).
2-3 While pressing on the lower part of D and E
from the outside, secure the bottom ends of
B using two tapping screws
4 (4 x 20 mm).
2-4 Insert the other two tapping screws 4 (4 x
20 mm) into the other two screw holes to
secure B.
2-5 Securely tighten the screws on the top of B
that were attached in Step 2-2.
3. Secure C.
Securely tighten the screws on C that were
attached in Step 1-3.
4. Mount A.
Be sure to place your hands at least 10 cm from
either end of A when positioning it.
CAUTION
• Fingers can become pinched between the main unit and the
rear or side panels, be extra careful so as not to drop the
main unit.
• Do not hold the keyboard in any position other than the
position shown in the illustration.
5. Secure A.
5-1 Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2 Secure A by tightening the short screws 2
(6 x 16 mm) from the front.
D
E
B
2
-
3
2
-
3
2
-
4
2
-
2, 2
-
5
2
-
1
Place the
bottom ends
of the rear
panel on
each foot.
3
C
B
D
E
B
A
At least
10 cm
At least
10 cm
5
-
1
5
-
2
Projection of A