User Manual

Keyboard Stand Assembly
31
YDP-S52 Owner’s Manual
2-4 Securely tighten the screws on the top of B
that were attached in Step 2-1.
3. Secure C.
3-1 Securely tighten the screws on C that were
attached in Step 1-3.
3-2 Attach the caps (6) to the head of the
screws.
4. Mount A.
Be sure to place your hands at least 10 cm from
either end of A when positioning it.
Align the dowels on D and E with the
corresponding holes on the bottom of A.
CAUTION
• Be careful not to pinch your fingers or drop the unit.
• Do not hold the keyboard in any position other than the
position shown in the illustration.
5. Secure A.
5-1 Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2 Secure A by tightening the short screws 3
(6 x 16 mm) from the bottom.
6. Connect the pedal cord
6-1 Insert the pedal cord plug to the
[TO PEDAL] jack from the rear.
6-2 Attach the cord holders 7 to the rear panel
as shown, then clip the cord into the holders.
6-3 Use a vinyl tie (Step 1-1) to take up any
slack in the pedal cord.
2-1, 2-4
2-3
D
E
B
2-2
2-2
Secure the anti-fall brackets (8) using the screws.
C
B
3-2
3-1
DE
A
DEB
At least 10 cm At least 10 cm
Insert the pedal cord securely
until the metal part of the cord
plug disappears from view.
Otherwise, the pedal may not
function properly.
5-1
5-2
A
A
Projection of A
6-1
6-2
6-3