Service manual

3 - 38
CHK
ADJ
CHECKING THE BRAKE FLUID LEVEL
1.Place the machine on a level surface.
N
OTE:
When checking the brake fluid level, make
sure that the top of the brake fluid reservoir top
is horizontal.
2.Remove: (rear brake)
●
Front carrier
●
Front fender panel
Refer to “SEAT, CARRIERS, FENDERS
AND FUEL TANK”.
3.Check:
●
Brake fluid level
Fluid level is under “LOWER” level line 1 →
Fill up.
È
Front brake
É
Rear brake
CAUTION:
Brake fluid may erode painted surfaces or
plastic parts. Always clean up spilled fluid
immediately.
WARNING
●
Use only the designed quality brake fluid:
otherwise, the rubber seals may
deteriorate, causing leakage and poor
brake performance.
●
Refill with the same type of brake fluid;
mixing fluids may result in a harmful
chemical reaction and lead to poor
performance.
●
Be careful that water does not enter the
master cylinder when refilling. Water will
significantly lower the boiling point of the
fluid and may result in a vapor lock.
4.Install: (rear brake)
●
Front fender panel
●
Front carrier
Refer to “SEAT, CARRIERS, FENDERS
AND FUEL TANK”.
Recommended brake fluid:
DOT 4
È
É
CHECKING THE BRAKE FLUID LEVEL
Not For Resale
www.SmallEngineDiscount.com