Service manual

7 - 14
DRIV
MEASURING AND ADJUSTING THE
DIFFERENTIAL GEAR LASH
Measuring the differential gear lash
1.Secure the gear case in a vise or another
supporting device.
2.Remove:
●
Drain plug
●
Gasket
3.Install:
●
A bolt of the specified size 1
(into the drain plug hole)
CAUTION:
Finger tighten the bolt until it holds the ring
gear. Otherwise, the ring gear will be
damaged.
4.Attach:
●
Gear lash measurement tool 1
●
Dial gauge 2
a
Measuring point is 21 mm (0.83 in)
5.Measure:
●
Gear lash
Gently rotate the gear coupling from
engagement to engagement
.
N
OTE:
Measure the gear lash at four positions. Rotate
the shaft 90° each time.
Gear lash measurement tool:
P/N. YM-01467, 90890-01467
Differential gear lash:
0.05 ~ 0.25 mm
(0.0020 ~ 0.0098 in)
FRONT CONSTANT VELOCITY JOINTS AND
DIFFERENTIAL GEAR
Not For Resale
www.SmallEngineDiscount.com