Service manual

GEN
INFO
1 - 12
SPECIAL TOOLS
YU-90050
Crankshaft installer set
These tools are used to install the
crankshaft.
Adapter
YM-33279
Spacer
90890-04060
YM-90070-A
Adapter (#11)
Spacer (crankshaft)
These tools are used to install the
crankshaft.
90890-01304
YU-01304
Piston pin puller set
This tool is used to remove the piston
pin.
90890-01311
YU-08035
Tappet adjusting tool (3 mm)
This tool is necessary for adjusting
the valve clearance.
90890-01312
YM-01312-A
Fuel level gauge
This gauge is used to measure the
fuel level in the float chamber.
90890-01325
YU-24460-01
Radiator cap tester
This tool is used to check the cooling
system.
90890-01352
YU-33984
Adapter
This tool is used to check the cooling
system.
90890-01348
Locknut wrench
This tool is needed when removing or
installing the secondary sheave
spring.
90890-04134
YM-04134
Sheave spring compressor
This tool is needed when removing or
installing the secondary sheave
spring.
Tool No. Tool name/How to use Illustration
Not For Resale
www.SmallEngineDiscount.com