Owner`s manual

8-24
8
To check the differential gear oil level
1. Place the ATV on a level surface.
NOTE:
The differential gear oil level must be checked on
a cold engine.
2. Remove the differential gear oil filler bolt, and
then check the oil level in the differential gear
case.
NOTE:
The oil level should be at the brim of the filler hole.
3. If the oil is below the brim of the filler hole, add
sufficient oil of the recommended type to raise
it to the correct level.
4. Install the oil filler bolt, and then tighten it to the
specified torque.
To change the differential gear oil
1. Place the ATV on a level surface.
2. Place an oil pan under the differential gear
case to collect the used oil.
3. Remove the differential gear oil filler bolt and
the differential gear oil drain bolt to drain the
oil from the differential gear case.
1. Differential gear oil
2. Differential gear oil filler bolt
3. Correct oil level
Tightening torque:
Differential gear oil filler bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
U1D913E0.book Page 24 Thursday, April 20, 2006 2:47 PM