Owner`s manual

4-8
4
● “4WD” (four-wheel drive): Power is supplied to
the rear and front wheels.
To change from two-wheel drive to four-wheel
drive, stop the ATV and push the switch in to the
“4WD” position. Then, the four-wheel-drive indica-
tor “” comes on in the multifunction meter unit
display.
To change from four-wheel drive to two-wheel
drive, stop the ATV and push the switch in to the
“2WD” position.
WARNING
EWB00120
1. On-Command four-wheel-drive switch “2WD”/“4WD”
POTENTIAL HAZARD
Changing from two-wheel drive to four-
wheel drive or from four-wheel drive to two-
wheel drive while the ATV is moving.
WHAT CAN HAPPEN
The ATV handles differently in two-wheel
drive than in four-wheel drive in some cir-
cumstances. Changing from two-wheel drive
to four-wheel drive or from four-wheel drive
to two-wheel drive while moving may cause
the ATV to unexpectedly handle differently.
This could distract the operator and in-
crease the risk of losing control and of caus-
ing an accident.
HOW TO AVOID THE HAZARD
Always stop the ATV before changing from
two-wheel drive to four-wheel drive or vice-
versa.
U1D913E0.book Page 8 Thursday, April 20, 2006 2:47 PM