Service manual

3 - 64
CHK
ADJ
CHECKING THE FUSES
EBS00121
CHECKING THE FUSES
The following procedure applies to all of the
fuses.
CAUTION:
_
To avoid a short circuit, always set the
main switch to “OFF” when checking or
replacing a fuse.
1. Remove:
• seat
Refer to “SEAT, FENDERS AND FUEL
TANK”.
2. Check:
• fuse
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Connect the pocket tester to the fuse and
check the continuity.
NOTE:
_
Set the pocket tester selector to “
Ω ×
1”.
b. If the pocket tester indicates “
∞
”, replace
the fuse.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
3. Replace:
• blown fuse
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Set the main switch to “OFF”.
b. Install a new fuse of the correct amperage.
c. Set on the switches to verify if the electrical
circuit is operational.
d. If the fuse immediately blows again, check
the electrical circuit.
Pocket tester
P/N. YU-03112-C, 90890-03112