Service manual

4 - 19
ENG
CYLINDER HEAD
NOTE:
*1: Tighten the cylinder head bolts to 30 Nm (3.0 m · kg, 22 ft · lb) in the proper tightening sequence,
remove and retighten the cylinder head bolts to 20 Nm (2.0 m · kg, 14 ft · lb) in the proper tightening
sequence, and then tighten the cylinder head bolts further in two steps of 90° to reach the specified
angle of 180° in the proper tightening sequence.
Order Job/Part Q’ty Remarks
4 Cylinder head 1 Refer to “REMOVING THE CYLINDER
HEAD” and “INSTALLING THE CYLIN-
DER HEAD”.
5 Cylinder head gasket 1
6 Dowel pin 2
7 Timing chain guide (exhaust side) 1
For installation, reverse the removal pro-
cedure.