Service manual

7 - 5
CHAS
2. Check:
• wheel bearings
Wheel hub play/wheel turns roughly →
Replace.
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Clean wheel hub exterior.
b. Drive bearing out by pushing spacer aside
and tapping around perimeter of bearing
inner race. Use soft metal drift punch and
hammer. The spacer 1 “floats” between
bearings. Remove both bearings as
described.
WARNING
_
Eye protection is recommended when
using striking tools.
c. To install the wheel bearings, reverse the
above sequence. Use a socket that
matches outside diameter of bearing outer
race to drive in bearing.
CAUTION:
_
Do not strike the center race or balls of the
bearing. Contact should be made only with
the outer race.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
1
EBS00389
CHECKING THE BRAKE DISCS
1. Check:
• brake discs
Galling/damage → Replace.
2. Measure:
• brake disc deflection
Out of specification → Check the wheel
runout.
• brake disc thickness a
Out of specification → Replace.
Brake disc maximum deflection
Front: 0.10 mm (0.004 in)
Rear: 0.10 mm (0.004 in)
Brake disc minimum thickness
3 mm (0.12 in)
FRONT AND REAR WHEELS