Service manual

7 - 17
CHAS
EBS00405
REPLACING THE REAR BRAKE PADS
NOTE:
_
It is not necessary to disassemble the brake
caliper and brake hose to replace the brake
pads.
1. Remove:
• brake pads
a
wear limit
NOTE:
_
Replace the brake pads as a set if either is
found to be worn to the wear limit.
2. Install:
• brake pads
• brake pad spring
NOTE:
_
Always install new brake pads, brake pad shim
and brake pad spring as a set.
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Connect a suitable hose
1
tightly to the
brake caliper bleed screw
2
. Put the other
end of this hose into an open container.
b. Loosen the brake caliper bleed screw and,
using a finger, push the caliper piston into
the brake caliper.
c. Tighten the brake caliper bleed screw.
d. Install a new brake pad spring, new pad
shim
3
and new brake pads.
NOTE:
• The pad shim must be installed toward the
piston.
• The arrow mark
a
on the pad shim must
point in the direction of the disc rotation.
e. Install the retaining bolts and brake caliper.
T
R
.
.
Brake caliper bleed screw
6 Nm (0.6 m · kg, 4.3 ft · lb)
T
R
.
.
Brake pad retaining bolt
18 Nm (1.8 m · kg, 13 ft · lb)
Brake caliper mounting bolt
31 Nm (3.1 m · kg, 22 ft · lb)
FRONT AND REAR BRAKES