Service manual

8 - 13
– +
ELEC
IGNITION SYSTEM
EBS01041
YES
NO
EBS01042
YES
NO
YES
NO
YES
NO
EBS01040
YES
NO
EBS01047
YES
NO
6. Main switch
• Check the main switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the main switch OK?
Replace the main
switch.
7. Engine stop switch
• Check the engine stop switch for continu-
ity.
Refer to “CHECKING THE SWITCHES”.
• Is the engine stop switch OK?
Replace the handle-
bar switch.
8. Throttle switch
• Check the throttle switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the throttle switch OK?
Replace the throttle
switch.
9. Carburetor switch
• Check the carburetor switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the carburetor switch OK?
Replace the carbure-
tor switch.
10.Pickup coil resistance
• Disconnect the pickup coil coupler from
the wire harness.
• Connect the pocket tester (
Ω ×
100) to the
pickup coil terminal as shown.
Positive tester probe
→
white terminal
1
Negative tester probe
→
red terminal
2
• Measure the pickup coil resistance.
Pickup coil resistance
248 ~ 372
Ω
at 20 °C (68 °F)
• Is the pickup coil OK?
Replace the pickup
coil/stator assembly.
11.Wiring
• Check the entire ignition system’s wiring.
Refer to “CIRCUIT DIAGRAM”.
• Is the ignition system’s wiring properly
connected and without defects?
Replace the C.D.I.
unit.
Properly connect or
repair the ignition
system’s wiring.
WR
21