Service manual

2 - 18
SPEC
TIGHTENING TORQUES
NOTE:
*1: Tighten the cylinder head bolts to 30 Nm (3.0 m · kg, 22 ft · lb) in the proper tightening sequence,
remove and retighten the cylinder head bolts to 20 Nm (2.0 m · kg, 14 ft · lb) in the proper tightening
sequence, and then tighten the cylinder head bolts further in two steps of 90° to reach the specified
angle of 180° in the proper tightening sequence.
Thermo switch 2 — M18 1 28 2.8 20
Starter motor Bolt M6 2 10 1.0 7.2
Starter motor lead Nut M6 1 7 0.7 5.1
Bush holder assembly and rear
bracket nut
Nut M6 1 7 0.7 5.1
Part to be tightened Part name
Thread
size
Q’ty
Tightening torque
Remarks
Nm m · kg ft · lb