Service manual

3 - 24
CHK
ADJ
CHANGING THE ENGINE OIL/
ADJUSTING THE CLUTCH CABLE
17.Check:
• engine oil pressure
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Slightly loosen the oil gallery bolt 1.
b. Start the engine and keep it idling until
engine oil starts to seep from the oil gallery
bolt. If no engine oil comes out after one
minute, turn the engine off so that it will not
seize.
c. Check the engine oil passages, the oil filter
element and the oil pump for damage or
leakage. Refer to “OIL PUMP” in chapter 4.
d. Start the engine after solving the problem(s)
and check the engine oil pressure again.
e. Tighten the oil gallery bolt to specification.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
18.Install:
• engine skid plate
Refer to “SEAT, FENDERS AND FUEL
TANK”.
T
R
.
.
Oil gallery bolt
10 Nm (1.0 m · kg, 7.2 ft · lb)
1
EBS00070
ADJUSTING THE CLUTCH CABLE
1. Check:
• clutch lever free play a
Out of specification → Adjust.
Clutch lever free play
(at the clutch lever end)
8 ~ 13 mm (0.31 ~ 0.51 in)
a