User Manual

19
Assembly
1-2

Position the pedal stay so the indentation is facing up, and insert the pedal stay all the way into
the receiver (low register side) on the leg (at this point, the wing bolt’s end is aligned with the
indentation on the pedal stay), then tighten the wing bolt to secure.
Attach the pedal stay assembly to the high register side in the same manner.
* Use the hole close to the indentation as a reference for aligning the pedal stay.
Wing bolt
Receiver
(low register side)
Indentation
Pedal stay
The illustration shows attachment of the pedal
stay to the low register side.
Wing bolt
Use this hole for aligning
Pedal stay
Leg
(low register side)
Indentation
1-3

After confirming that both right and left legs are standing vertically, attach one end of the leg
stay that is attached to the pedal stay, onto the leg (low register side) using the wing nut locat-
ed between the two upright legs, and tighten the wing nut to secure.
* Slide the end of the stay firmly onto the bolt.
End of leg stay
Wing nut
Leg stay
Leg
(low register side)
02_yg2500_en_new.indd 19 14/08/26 11:25