Owner's Manual
YH-WL500 Owner’s Manual 13
Basic Operations
1. Turn on the power of your connected
devices.
Also in this step, lower the volume of those
devices.
2. Remove the fully charged headphones from
the transmitter.
The status LED of the transmitter and the power
LED of the headphones flash in blue and a wire-
less channel is set up automatically.
If successfully connected, you will hear a “Pairing
Successful” audio message, and then the power
LED lights continuously in blue.
3. Put the headphones on.
Check the markings for the left and right sides to
make sure the headphones are positioned cor-
rectly when you put them on.
4. Adjust the volume of your device as
desired.
Follow the steps below to adjust the volume.
• Turning the volume up:
Press the + key.
• Turning the volume down:
Press the − key.
• Turning the volume up continuously:
Hold down the + key.
• Turning the volume down continuously:
Hold down the − key.
While using this product, you can check the
status of the audio input from the status LED of
the transmitter.
When the audio input is too high, the status LED lights
up in red. Lower the volume of the connected device.
Using the Headphones
Tra n s mi tte r
Flashes
in blue
Status LED
Power LED
Flashes
in blue
RL
Adjusting the Volume
• When volume reaches the maximum, you will hear a
“beep” sound.
Checking the Audio Input Status
− key
+ key
NOTE
Blue
Red
Status LED
\KZOBHQERRN࣮࣌ࢪ㸰㸮㸰㸰ᖺ㸯㸰᭶㸯㸷᪥ࠉ᭶᭙᪥ࠉ༗๓㸷㸰㸵ศ