Owner's Manual
Basic Operations
YH-WL500 Owner’s Manual14
While you are using the headphones, you can
check how much battery power is left from an
audio message.
Audio message
• Battery Low: small amount of charge remaining
1. When you are finished using the head-
phones, make sure to turn the power off by
holding down the power key.
2. Charge the headphones by setting them on
the transmitter (p.12).
By connecting this product directly to a device
by cable, you can use it conventionally without
having to use the power supply.
1. Turn the power of this product off by holding
down the power key.
2. Lower the volume of your equipment.
3. Connect the headphone jack of your equip-
ment to the input jack of the headphones by
using the 3.5 mm stereo mini-plug cable
(included).
4. Adjust the volume of the connected device
as desired.
Use the attached audio conversion plug according to
the shape of the headphone jack of your equipment.
Checking Remaining Battery
Power
After Using the Headphones
Hold
down
Connecting by Cable
• The following functions are not available when connecting
via cable.
- Adjusting the volume by pressing the + key (or the − key)
- Wireless connection
• When using this product with the cable connected, you
cannot use it with the power turned on. Use the head-
phones after turning off the power by holding down the
power key.
3.5 mm stereo
mini-plug cable
(included)
NOTE
\KZOBHQERRN࣮࣌ࢪ㸰㸮㸰㸰ᖺ㸯㸰᭶㸯㸷᪥ࠉ᭶᭙᪥ࠉ༗๓㸷㸰㸵ศ