Manualshelf

User Manual

ManualsBrandsYamaha ManualsHome AudioYHT-2A
12345678910
3 En
English
■ Connecting to an amplifier
Connect each speaker to the appropriate speaker terminals on your
amplifier by using the cables you prepared earlier.
Please refer to the owner’s manual that came with your amplifier
or receiver.
The front cover is fastened to the enclosure at six points and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the speaker. To reattach, line up the six holes on the speaker with
the six corresponding pegs on the inner surface of the cover and push gently.
• When removing or attaching the grille, be careful not to touch
the drive units, and not to exert excessive force with any tools.
• Do not touch or apply impact to the speaker’s diaphragm.
Otherwise, the speaker may malfunction.
• To avoid damaging the grille, never apply excessive force, and
be sure to use its frame, never pull or push the surface, for
removing or attaching the grille.
Type.................................................................... 2-way bass reflex
Magnetic shielding type
Driver ............................. Woofer: 16 cm (6-1/2") cone type x 2
Tweeter: 3 cm (1") soft dome type
Nominal input power ......................................................... 80 W
Maximum input power .................................................... 240 W
Impedance ............................................................... Nominal 6 Ω
Frequency response ........................................... 43 Hz - 26 kHz
Sensitivity.........................................................89 dB/2.83 V, 1 m
Dimensions (W x H x D)
........................... 233 x 973.5 x 254 mm (9-1/8" x 38-3/8" x 10")
We ig ht ................................................................13.7 kg (30.2 lbs)
Specifications are subject to change without notice.
SPEAKERS
A
B
L
R
+
+
–
–
Right Left
Amplifier
or Receiver
Speakers output
terminals
Removing / Attaching the grille
Specifications
Note