User Manual

11 En
Placing
PREPARATION
■ Attaching the speaker to a wall
Installing the speaker using the keyholes
You can attach the speaker to a wall using
commercially available screws (#8, Diameter: 7 to 9
mm (1/4” to 3/8”)).
1 Attach the supplied mounting template on
a wall and mark the holes of the mounting
template.
2 Remove the mounting template and then
install the commercially available screws
at the marks.
3 Hang the speaker on the screws using the
keyholes on the back of the speaker.
Installing the speaker using the screw
holes
You can also use the screw holes on the rear of the
speaker for installing the speaker using a
commercially available rack etc.
• Attach the speaker to a rack or wall. Do not attach the
speaker to a wall that is made of weak materials such as
plaster or veneered woods. Doing so may cause the
speaker to fall.
• Use commercially available screws that can support the
weight of the installation.
• Make sure you use specified screws to attach the speaker.
Using clamps other than specified screws, such as short
screws, nails, or two-sided tape, may cause the speaker to
fall.
• When connecting the speaker, fix the speaker cables in
place where they will not become loose. If your foot or
hand accidentally gets caught on a loose speaker cable, the
speaker may fall.
• After attaching the speaker, check that the speaker is fixed
securely. Yamaha will bear no responsibility for any
accidents caused by improper installations.
When installing the speaker on a wall, all
installation work must be performed by a
qualified contractor or dealer. The customer
must never attempt to perform this installation
work. Improper or inadequate installation could
cause the speaker to fall, resulting in personal
injury.
Tapes or thumbtacks
Mark
4 to 6 mm (3/16” to 1/4”)
Diameter:
7 to 9 mm or
more (#8, 1/4”
to 3/8” or more)
Notes
Screw holes
Hole depth: 14 mm (9/16”)
Diameter: 6 mm (1/4”)
Pitch: 256 mm (10-1/16”)
256 mm
(10-1/16”)
37 mm (1-7/16”)
Rack etc.
14 mm (9/16”)
Screw
(M6)
Screw
hole
Min 7 mm (1/4”)
NS-BR300