User Manual

14 En

BASIC OPERATION

Once you have finished all cable connections and remote control operation, follow the procedure below to start

basic playback operation.

1 Press .

This system is turned on and the STATUS

indicator lights green.

This system has the auto-sleep function, which will

automatically switch the system to turn off if the

system is left turned on for 24 hours without any

operation being performed.

2 Press one of the input buttons to select

an input source.

3 Start playback on the selected external

component.

For information on the external component, refer

to the instruction manual for the product.

4 Press VOLUME +/– to adjust the volume

level.

To turn off the volume temporarily, press MUTE.

While the mute function is activated, the VOLUME

indicator flashes. To resume the volume, press MUTE

again or press VOLUME +/–.

When sound of HDMI is output from the TV, the

volume level does not change if you press VOLUME

+/–.

■ Using the remote control

Basic playback operation

Note

Press again to set the system to

standby mode.

When the “HDMI CONTROL” is set to “ON”, the

STATUS indicator lights red. When the “HDMI

CONTROL” is set to “OFF”, the STATUS indicator

turns off. (☞ P. 21)

Within 6 m (20’)

Use the remote control within 6 m (20’) of the

subwoofer integrated receiver and point it toward the

remote control sensor.

• Be careful not to spill liquid on the remote control.

• Be careful not to drop the remote control.

• Do not leave the remote control in a place that is:

– hot or humid, such as near a heater or in a bathroom

–extremely cold

–dusty

Notes