User Manual

5 En
To charge your iPod/iPhone, connect it to the transmitter, and then station the transmitter with
your iPod/iPhone onto the receiver.
Do not push the transmitter detection switch hard.
If the unit does not function properly, first of all, check the firmware of your iPod/iPhone is the latest version.
If it is the latest version, refer to the table below. If the problem you are experiencing is not listed below, or if
the instruction below does not help, contact the nearest authorized Yamaha dealer or service center.
4: Battery charge
A
B
1
2
3
Note
A
B
1
2
3
Transmitter detection switch
Troubleshooting
Transmitter
LED
Problem Cause Remedy
Green: Off
Red: Off
No sound. No sound is output from
your iPod/iPhone.
Playback your iPod/iPhone,
or run the YouTube or other
applications.
Your iPod/iPhone is not
connected to the transmitter
firmly.
Reconnect your iPod/iPhone
to the transmitter firmly.
The battery of your iPod/
iPhone is empty.
Charge your iPod/iPhone.
Green: flashes
Red: Off
No sound. The dock cable is not
connected to your Yamaha
component.
Connect the dock cable to
your Yamaha component.
The group IDs of the
transmitter and receiver are
set to the different value.
Match the group IDs.
The power is not supplied to
the receiver from your
Yamaha component.
Change the setting of your
Yamaha component
referring to its owner’s
manual.