User Manual

ASSEMBLY

YM-410D

Insert the rail (1) into the frame ends of the legs.

4-1. Insert the outer rail (1) in the same way as the inner rails (2), (3) and (4).

A mark “A” is printed on the large end face of the rail (1) and the groove section of the frame end

of the large end leg.

Set the tone bars.

5-1. While adjusting the long frame, engage the rail clamp on rail (2) and rail (3) with rail (1) and rail (4),

respectively.

Once again, confirm that all screws are tightened firmly.

5-2. Set the natural tone bars rst.

With one person holding the suspension cord on the bass side and the other holding the suspen-

sion cord on the treble side securely with both hands, gently place the tone bars on the rails.

Align each tone bar individually and hook its cord onto the corresponding tone bar post.

After conrming that the cord is secured to every post, x the tone bars by pulling the right and left

cords forward from the large end side and hooking the two springs into each other.

* When setting the tone bars, use care not to cause any damage to them.

Small end

Large end

Springs

Suspension cord

Rail clamp

Rail (4)

Rail (2)

Rail (3)

Rail clamp

Rail (1)