User Manual

23
ASSEMBLY
1-2. Connect the reinforcement stays at the center. Align the end of the xing bolt and the holes in the
reinforcement stays and tighten the xing bolt securely.
1-3. Install the reinforcement stay to the large end leg.
Insert the “E” marked end of the reinforcement stay (with its slant shaft facing down) into the joint
(marked with “E”) on the large end leg until it stops and tighten the xing bolt securely.
In the same way, install the reinforcement stay to the small end leg. (There is no marking on the
small end joint.)
Reinforcement stay
(Large end)
Reinforcement stay
(Small end)
Screw hole
Slant shaft
Leg (Large end)
Wing nut
1-4. After making sure that both legs are perpendicular to the oor, t the end of each slant shaft to the
wing nut located in the lower part of each leg and tighten it securely.
* Make sure that the slant shaft is securely fitted.
Leg (Large end)
Reinforcement stay (Large end)
Fixing bolt