manual

ManualsBrandsYamaha Manualsaudio & home theatreYMC-700

Software Update Procedure for YMC-700

Page.1 of 3

IMPORTANT NOTICE

Do not attempt to update your neoHD using any other data file except those provided directly from

the Yamaha website or through your network connection.

Follow the instructions carefully and do not attempt any other procedures not specified in the

instructions provided by Yamaha.

Improperly updated products may cause improper operation, and any parts or service required to

restore proper operation will not be covered under the Yamaha Limited Warranty.

The following pages contain the software update instructions for neoHD Media

Controller, YMC-700. You can easily apply the latest software through the Internet or

by using a USB thumb drive. In order to properly execute the update, read all

instructions carefully.

Note:

If your neoHD is connected to the Internet, “Network Update” is recommended. In this

case, USB thumb drive is unnecessary.

Simply select: Setup > Update > Network Update

Summary of content (3 pages)

PAGE 1
Software Update Procedure for YMC-700 IMPORTANT NOTICE Do not attempt to update your neoHD using any other data file except those provided directly from the Yamaha website or through your network connection. Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by Yamaha. Improperly updated products may cause improper operation, and any parts or service required to restore proper operation will not be covered under the Yamaha Limited Warranty.
PAGE 2
Software Update Procedure for YMC-700 PREPARATION Download the corresponding software file, “YMC700_FIRMWARE_Vxxx.zip” for your neoHD from Yamaha website. Unzip and copy the software file to the root folder of your USB thumb drive The software file, YMC700_xxx.bin Note: We recommend that you DO NOT store any other files or documents on your thumb drive during this software update PROCEDURE STEP1 Insert USB thumb drive to the USB terminal located on the rear side of your neoHD.
PAGE 3
Software Update Procedure for YMC-700 STEP3 Enter USB Update. From the TOP MENU, select “Setup”. “Update”. Move cursor down and select Select “USB Update” and when “Start updating?” appears, select “Yes”. Note: In case “Update file is not found” appears on your TV, the data in your USB thumb drive may have some issue. Re-copy the software data (BIN file), and retry. Make sure the software is stored in the root folder of your thumb drive. If the software is stored in a folder, neoHD can’t detect it.