Service manual
YSP-1
14
YSP-1
●操作方法
● Operation Procedure
For CPU
1. Install FlashSta.exe into the PC.
2. Before turning on the power to YSP-1 and PC, connect
between RS232C ports with the RS232C cable (cross
cable). (Fig. 1)
3. While pressing the reset switch of YSP-1, connect the
power cable to the AC outlet. (Fig. 1)
* Use a fine tipped pin or the like to push the reset
switch.
4. Start up FlashSta.exe, the screen will appear as shown
below.
・Select Program
・RS232C
5. Select the data to be transmitted and port.
· Select Program
Select Internal flash memory
· RS232C
Select the port of RS-232C
Select the port of RS-232C
接続しているRS-232Cポートを選択します
Select Internal flash memory
Internal flash memoryを選択します
* For selection of the port, COM1 to 4 can be used.
As COM5 or higher port cannot be used, select
out of COM 1 to 4 of the setting on the PC side.
BOTTOM VIEW
RS-232C Port
Reset Switch
Fig. 1