Owner's Manual

4
En
Installations
Place the unit on a flat surface such as on top of a TV
cabinet.
Attaching the unit to a wall
How to install on the wall
1 Attach the mounting template on a wall and mark
for the screw holes.
2 Remove the mounting template from the wall and
install the commercially available screws at the
marks on the wall.
3 Hang the unit on the screws.
Cautions
• Do not place the unit on/under any other devices such as BD
player in a pile. Doing so may cause a malfunction due to
vibrations.
• The unit contains acoustic suspension speakers. Do not place
magnetically sensitive items (hard disk drive, etc.) near unit.
• Depending on your installation environment, it may be better to
connect the unit and external devices (such as a TV) before
installing the unit.
• Do not place the unit within 50 mm (2") of the TV. The wall mount
brackets on the rear panel can be removed as necessary.
Cautions
• When installing the unit on a wall, all installation work must be
performed by a qualified contractor or dealer. The customer must
never attempt to perform this installation work. Improper or
inadequate installation could cause the unit to fall, resulting in
personal injury.
• Do not attach the unit to a wall that is made of weak materials
such as plaster or veneered woods. Doing so may cause the unit
to fall.
• Make sure you use commercially available screws that can
support the weight of the installation (specified in Step 2 on the
right). Using clamps other than specified screws, such as short
screws, nails, and two-sided tape, may cause the unit to fall.
Cautions
• Fix the cables in place where they will not become loose. If your
foot or hand accidentally gets caught on a loose cable, the unit
may fall.
• Check that the unit is fixed securely after the installation. Yamaha
will bear no responsibility for any accidents caused by improper
installations.
Tapes or thumbtacks
Mounting template (supplied)
Screw
holes
7 to 9 mm
(1/4" to 3/8")
2 to 4 mm (1/16" to 3/16")
4 mm (#8)
20 mm (3/4")
or more
Mounting holes
on rear of unit