Manual

SETTINGS ➤ Setup menu En 72
Beam
When “AUTO SETUP” in the “IntelliBeam” menu (p. 33) is used, recommended beam settings are automatically applied by this unit. However, “Horizontal Angle”, “Beam Travel
Length”, “Focal Length” (except “Center”), and “Image Location” settings can later be fine-tuned.
The output method for each channel can also be specified in “Beam” menu.
• When manually adjusting sound beams for the front channels, set “Front” for “Channel Out” to “Beam” or “Mix”. Adjustment is not possible if “Front” is set to “Stereo”.
Adjust the horizontal angle of sound beams for each channel using test tones.
Adjust toward L (left) to move the direction of the output to the left and adjust toward R
(right) to move it to the right.
Settings
Front L, Front R, Center, Surround L, Surround R
Adjustable range
L90° to R90°
Specify the distance that sound beams travel for each channel. The distance starts at
this unit, ends at the listening position, and includes refraction off a wall. The audio
delay is adjusted and sound from each channel arrives at the listening position
simultaneously.
Settings
Front L, Front R, Center, Surround L, Surround R
Adjustable range
0.3 m to 24.0 m (1.0 ft to 80.0 ft)
• Configure this setting only when you have adjusted “Horizontal Angle”.
Horizontal Angle
Setup Menu
➜
Beam
➜
Horizontal Angle
Beam angle
Angle to
left
Angle to
right
Left
W key:
Increase angle.
X key:
Decrease angle.
Right
X key:
Increase angle.
W key:
Decrease angle.
Beam Travel Length
Setup Menu
➜
Beam
➜
Beam Travel Length
The length of each
arrow indicates the
beam travel length.