manual

YSP-5600 Firmware Update Procedure Manual
1. Introduction
This document is firmware update procedure manual for YSP-5600 using USB package.
2. Procedure
1. Unplug the cable of YSP-5600
2. Put USB package for YSP-5600 in USB flash memory
3. Connect USB flash memory to YSP-5600
4. Press-and-hold “volume -“ button and plug in the cable
5. “FW Update” indication is appeared on FL
6. Wait for firmware updating process is finished
7. If “Success!” was displayed on FL, the firmware updating was completed. Please power off
YSP-5600. If some error was occurred, please check the meaning of the error referencing “3.
Indication and Meaning”.
3. Indication and Meaning
Some informations are displayed on FL. The following table is informations and meanings.
Page  of 1 3
Note : If some progress was stopped more than 3 minutes, some problem might be occurred.
Please power off YSP-5600 and try again.