Owner's Manual
Table Of Contents
- Owners Manual
- Table of Contents
- Features
- Supplied Accessories
- Parts & Controls
- Preparations
- Playback
- Basic operation for playback
- Enjoying sound based on your preference
- Playback with 3D surround sound
- Playback with surround sound
- Enjoying three-dimensional surround sound (CINEMA DSP 3D/CINEMA DSP)
- 2-channel playback (stereo playback mode)
- Delivering sound to a specified location (target playback mode)
- Playing back digitally compressed formats (such as MP3, etc.) with enriched sound (Compressed Music Enhancer)
- Clear playback of human voices (CLEAR VOICE)
- Adjusting the position from which dialog is heard (Dialog Lift)
- Adjusting volume for each channel
- Using useful features
- Wireless playback of audio via Bluetooth connection
- Networks
- Settings
- Troubleshooting
- Messages
- When surround effect is not enough
- Basic Knowledge of Surround Sound
- Glossary
- Specs
- Index
- Quick Reference Guide
- MusicCast Setup Guide
- Supplement for Pandora
- Supplement for Rhapsody
- Supplement to Listen to SiriusXM
- Supplement for Spotify
PREPARATIONS ➤ a Installation En 12
This unit reflects sound beams off of walls and a ceiling to create the surround sound effect. The position of this unit in relation to the listening position, walls, and a ceiling is important
to achieving the desired surround sound effects. Refer to pages 12 to 16 when installing the unit. When installing this unit on a rack behind which there is limited space, for example,
it may be easier to connect external devices to this unit first. This will depend upon the installation location. See pages 22 to 25 for information regarding the connection of external
devices.
a Installation
Notes
• Be sure to install this unit on a large, stable stand where it does not fall subject to vibrations, such as from an earthquake, and where it is out of the reach of children.
• There is a built-in antenna on the top of the unit. Do not install it on a metal rack, and do not stack metal items on top of the unit.
• The unit’s speakers are not magnetically shielded. Do not install hard disk drives or similar devices near the unit.
• Do not stack the unit directly on top of other playback devices, or vice versa. Heat and vibrations may result in damage or malfunction.
Recommended place for installation
1
Height channel audio is output in a diagonal
direction upward and forward from the unit (p. 5).
2
Depending upon the rack, table-top stand, or
floor stand used, the stands may not be
necessary.
• Install the unit in the center of the left and right
walls.
• This unit can be mounted on a wall (p. 17).
• The listening position (such as sofa, etc.) should be
located at the front of the unit.
• The distance between the listening position and the
unit should be more than 1.8 m (6 ft).
• Set the listening position as far from the back wall as
possible (the optimal listening position is halfway
between the unit and the back wall, or slightly closer
to the back wall).
• To achieve desired surround sound effects, be
sure that obstacles such as furniture may not
obstruct the path of sound beams (p. 13).
• Be sure that the unit installed with at least 5 cm
of empty space above and below it.
• Leaving as much space as possible in a
diagonal direction in front of, and above, the
unit when installing it.
1
• Attach the supplied stands to the unit if it will
be installed on a rack
2
(p. 16).
1 2 3 4 5 6