Owner's Manual
Table Of Contents
- Owners Manual
- Table of Contents
- Features
- Supplied Accessories
- Parts & Controls
- Preparations
- Playback
- Basic operation for playback
- Enjoying sound based on your preference
- Playback with 3D surround sound
- Playback with surround sound
- Enjoying three-dimensional surround sound (CINEMA DSP 3D/CINEMA DSP)
- 2-channel playback (stereo playback mode)
- Delivering sound to a specified location (target playback mode)
- Playing back digitally compressed formats (such as MP3, etc.) with enriched sound (Compressed Music Enhancer)
- Clear playback of human voices (CLEAR VOICE)
- Adjusting the position from which dialog is heard (Dialog Lift)
- Adjusting volume for each channel
- Using useful features
- Wireless playback of audio via Bluetooth connection
- Networks
- Settings
- Troubleshooting
- Messages
- When surround effect is not enough
- Basic Knowledge of Surround Sound
- Glossary
- Specs
- Index
- Quick Reference Guide
- MusicCast Setup Guide
- Supplement for Pandora
- Supplement for Rhapsody
- Supplement to Listen to SiriusXM
- Supplement for Spotify
16 En c Auto setup for appropriate surround effects (IntelliBeam)
4
Press the ENTER key to start the AUTO SETUP
procedure and then leave the room within 10
seconds.
If the AUTO SETUP procedure is complete, this unit rings
the chimes.
• The AUTO SETUP procedure takes about 3 minutes.
• To cancel the AUTO SETUP procedure after it is started, or if you do not
want to apply the results, press the RETURN ( ) key.
• If an error occurs, an error buzzer sounds and an error message is
displayed. For details on error messages, see page 33 in the Owner’s
Manual.
5
Press the ENTER key.
The measurement results are applied and saved in the unit.
• You can save several measurement results by pressing
the SYSTEM MEMORY 1, 2, or 3 key.
When the SYSTEM MEMORY 1 key is pressed, “M1
Saving” is displayed, and settings are saved.
• If ambient noise is picked up after measurement begins,
an error message is displayed in the “AUTO SETUP
COMPLETE” screen prompting you to begin
measurement again. Press the ENTER key to exit the
error message screen, and begin measurement again.
• See page 44 in the Owner’s Manual for more information on the system
memory function.
6
Remove the IntelliBeam microphone.
The “AUTO SETUP COMPLETE” screen closes.
The IntelliBeam microphone is sensitive to heat, so should
not be placed anywhere where it could be exposed to direct
sunlight or high temperatures (such as on top of AV
equipment).
SHOW RESULT
MEASUREMENT COMPLETE.
ENVIRONMENT CHECK:Success
FRONT :Beam
SURROUND :Beam
SUBWOOFER:Wired
[ENTER]:Save set-up.
[RETURN]:Do not save set-up.
AUTO SETUP START
Will begin in 10 sec.
Please leave the room.
----------
[RETURN]:Cancel
The screen changes
automatically as measurement
progresses.
AUTO SETUP COMPLETE
Please remove the MIC
from Sound Projector
and the listening position.
Press [SYSTEM MEMORY] key
to save set-up in the memory.
INTELLIBEAM MIC
INTELLIBEAM MIC
RETURN ( )
SYSTEM
MEMORY
ENTER
1 2 3 4