Owner's Manual
Table Of Contents
- Owners Manual
- Table of Contents
- Features
- Supplied Accessories
- Parts & Controls
- Preparations
- Playback
- Basic operation for playback
- Enjoying sound based on your preference
- Playback with 3D surround sound
- Playback with surround sound
- Enjoying three-dimensional surround sound (CINEMA DSP 3D/CINEMA DSP)
- 2-channel playback (stereo playback mode)
- Delivering sound to a specified location (target playback mode)
- Playing back digitally compressed formats (such as MP3, etc.) with enriched sound (Compressed Music Enhancer)
- Clear playback of human voices (CLEAR VOICE)
- Adjusting the position from which dialog is heard (Dialog Lift)
- Adjusting volume for each channel
- Using useful features
- Wireless playback of audio via Bluetooth connection
- Networks
- Settings
- Troubleshooting
- Messages
- When surround effect is not enough
- Basic Knowledge of Surround Sound
- Glossary
- Specs
- Index
- Quick Reference Guide
- MusicCast Setup Guide
- Supplement for Pandora
- Supplement for Rhapsody
- Supplement to Listen to SiriusXM
- Supplement for Spotify
NETWORKS ➤ Connecting to a network En 53
10
Display the Wi-Fi setup screen on the iOS device
and select the unit from “SETUP A NEW AIRPLAY
SPEAKER...”.
Follow the on-screen instructions displayed on the iOS
device.
You can easily set up a wireless connection with one push of the
WPS button on the wireless router (access point).
1
Press the z key to turn on this unit.
2
Press and hold the WPS key on the remote control
for at least 3 seconds.
“Press WPS button on Access Point” will be displayed in the
front panel display.
• To cancel configuration, press any key other than the WPS key.
3
Push the WPS button on the wireless router (access
point).
When a connection has been established, “Completed” will
be displayed in the front panel display.
If “NotConnect” is displayed, repeat the procedure from
step 1 again, or see the information below to try another
connection method.
• The WPS button cannot be used to establish a wireless connection if your
wireless router (access point) uses WEP encryption, or if the router’s MAC
address filter is enabled. See “Searching for a wireless router (access point)”
(p. 53) to establish a connection.
• The WPS button cannot be used to establish a wireless connection if your
wireless router (access point) is configured so that it does not broadcast its SSID.
See “Setting up the wireless connection manually” (p. 55) to establish a
connection.
• “WPS Button” under “Wireless (Wi-Fi)” in the setup menu can also be used to
configure a connection using the WPS button. Follow the on-screen instructions.
Find and connect to a nearby wireless router (access point).
1
Press the z key to turn on this unit.
2
Turn on the TV and switch the TV input to display
video from the unit (HDMI OUT jack; p. 27).
3
Press the SETUP ( ) key twice.
The setup menu is displayed on the TV screen.
4
Use the S/T keys to select “Network”, and then
press the ENTER key.
5
Use the S/T keys to select “Network Connection”,
and then press the ENTER key.
Using the WPS push button configuration
About WPS
WPS (Wi-Fi Protected Setup) is a standard established by the
Wi-Fi Alliance, which allows easy establishment of a wireless
home network.
Searching for a wireless router (access
point)
Wireless(Wi-Fi)
Select a setup method.
·WPS Button
·Share Wi-Fi Settings (iOS)
·Access Point Scan
·Manual Setting
·PIN Code
[ENTER]:OK
[RETURN]:Cancel
z
/
ENTER
SETUP ( )
WPS