Manual
• Decoder indicators
Depending on the input source and the selected surround
mode, the decoder indicators in the front panel display
light up as follows:
Status Indicator
When PCM signals are being input PCM
When DTS digital signals are being
input o1"DTS Neo:6 is selected as
the surround mode
When Dolby Digital signals are
being input rlrl DIGITAL
When Dolby Pro Logic is selected
as the surround mode [lrl PL
When Dolby Pro Logic II is selected
as the surround mode rlF1PL II
• You can select an input )node (AUTO, DTS, or ANALOG) by
pressing INPUTMODE repeatedly (see page 73).
• Discs encoded in DTS-ES, Dolby Digital 5.1 EX, Dolby Digital
EX, or Dolby Digital Surround EX will be played back in DTS
or Dolby Digital.
mm
qf/,_,/_,/,E-'t't'r'1" r'm'_'1" *'
Surround modes and recommended
sources
Cinema Movies
DTS Neo:6
Music Music
Dolby Pro Logic - All sources
Movie Movies
Dolby Pro Logic II Music Music
Game Games
• When you select an input source (see page 42), the surround
)node used for the previously selected input source is
automatically selected.
• If the power of this unit is turned off and on again, the surround
)node used for the previously selected input source before the
power was turned off is automatically selected.
• If the surround )nodes are not available, "Prohibit" appears in
the front panel display when you press SUR. DECODE.
• The surround modes are available:
- when the beam )node is set to a setting other than the stereo
playback (see page 51 ), My Beam (see page 52), and My
Surround (see page 46).
- when 2-channel signals are being input.
47 E,,